INSTALL SAFETY LATCHES #8 AS SHOWN ABOVE FOR PROPER USE OF
TABLE! DO NOT SKIP THIS STEP! DO NOT OPERATE TABLE UNTIL SAFETY
LATCHES ARE INSTALLED AND ASSEMBLY IS COMPLETE!
CAUTION:
10
8
16
17
10
#10-24 X 3/4 Round
Head Screw
(
Qty. 2
)
#10-24 Lock Nut
(
Qty. 2
)
#10 Flat Washer
(
Qty. 2
)
Hardware Needed
27.
Choose a name panel #5 on either side of the table and install one safety latch #8 into the
right-hand hole on that name panel as shown in
Figures 10, 11 & Detail J.
Use one screw
#10 one washer #17 and one hex nut #16.
NOTE: Flange on safety latch must extend
over top of name panel as shown in Detail K. Safety latch must pivot freely.
28.
Go to the other side of the table and install the second safety latch into the right-hand hole on
the other name panel #5.
NOTE: Safety latches must be attached diagonally across
from each other. See Figure 11.
Detail K
Detail J
Figure 10
Figure 11
14
