10.
Line up holes in rails with indentations in
top and secure using
eighteen
screws
#20. See
Figure 6
&
Detail E1 & E2
.
26
25
20
Shorter Distance
Longer Distance
35 (RH)
Note:
Legs not
shown for Clarity
8.
Lay out Right Side Rails #25, Left Side Rails
#29 and End Rails #26, around edges of
table top as shown in
Figure 6
.
20
9.
Slide Left #36 and Right #35 Vinyl End
Caps onto the ends of the Side Rails #25
& 29 as shown in
Detail E1 & E2
.
Detail E2
11.
Lay Corner Caps #22 on table as shown
in
Figure 6
. If Corner Cap sticks above
the table top surface of the table, flip
over so shorter distance is against edge.
Secure to bottom of table with three
Screws #21. See
Detail F
.
Detail F
Note:
Rails attach
with #20 screws
20
Note:
U-Support not
shown for Clarity
(RH Rail)
Note:
Prince
logo must be on
this end of Rail.
(LH Rail)
29
Note:
Prince
logo must be on
this end of Rail.
21
#8 x 1 7/16
Sheet Metal Screw
(
Qty. 6
)
#8 x 7/16
Sheet Metal Screw
(
Qty. 18
)
HARDWARE NEEDED
IF USING AN ELECTRIC SCREWDRIVER PLEASE SET AT LOW TORQUE AND USE CAUTION
BECAUSE YOU COULD OVER-TIGHTEN THE HARDWARE AND STRIP SCREW IN WOOD
DOING IRREPARABLE DAMAGE TO THE TABLE. DO NOT OVER TIGHTEN SCREWS!
CAUTION:
8
36 (LH)
20
Detail E1