21
EN
217400: Mounting the bottle (fig. B)
Fig. B1: Loosen the lid (9) from the bottle (8).
•
Fig. B2: Place the seal ring (4) onto the blade (3). Tighten the blade (3)
•
onto the bottle (8).
Fig. B3: Turn the bottle (8) upside down. Place the bottle (8) onto the
•
appliance. Lock the bottle (8) by turning it clockwise until it clicks into place.
Use
Switching on and off (fig. A)
Before you proceed, we need you to pay attention to the following notes:
Do not switch on the appliance when the jar or the bottle is empty.
Do not leave the appliance switched on continuously for more than
two minutes. After two minutes, switch off the appliance and allow it
to cool down for three minutes before switching it on again.
To switch on the appliance with continuous low speed, set the on/off
•
switch (1) to the "I" position.
To switch on the appliance with continuous high speed, set the on/off
•
switch (1) to the "II" position.
To switch on the appliance in pulse mode, set the on/off switch (1)
•
to the "P" position.
To switch off the appliance, set the on/off switch (1) to the "O" position.
•
Hints for use
Before you proceed, we need you to pay attention to the following notes:
Do not exceed the maximum mark on the juice level indicator.
Do not overload the appliance. Do not put too many ingredients into
the jar or the bottle at one time. If the motor stops, immediately
switch off the appliance, remove the mains plug from the wall socket
and allow the appliance to cool down for at least 10 minutes.
Cut the fruit and/or vegetables into pieces. Make sure that the pieces
•
of fruit and/or vegetables fit in the jar or the bottle.
Put the pieces of fruit and/or vegetables into the jar or the bottle.
•
Assemble the appliance. Refer to the section "Assembly".
•
Insert the mains plug into the wall socket. The power indicator comes on.
•
Summary of Contents for 217000
