GTIB-30 Installation Manual-UL
60
4411-0011, Rev 2.0
√
Item
Info
Measure and verify grid voltage in
range and frequency on grid side of
external grid disconnect
Only performed when grid is available
Close external grid disconnect
Only performed when grid is available
Measure grid voltage and frequency
in range and correct sequence inside
GTIB-30 on terminal blocks
Only performed when grid is available.
Open integrated DC disconnect
Open external DC disconnect
24V power supply inside GTIB-30 will
power down again if on previously.
Open external Grid disconnect
Wait 5 minutes for internal DC Bus
to discharge
Close external DC disconnect
Ensure integrated battery disconnect is open!
24 V PSU inside GTIB-30 will power up if
battery is sufficiently charged.
Close external Grid disconnect
Only performed if grid is available
Close integrated DC disconnect
Close integrated grid disconnect
Only necessary when grid connection
available. 24 V PSU in GTIB-30 will power
up if battery was insufficiently charged and
grid is available.
Close integrated control power
disconnect
HMI and other control systems should power
up.
Close and lock enclosure front door
Verify correct grid voltage and
frequency measurements on HMI
Refer to GTIB-30 user manual for HMI
operation.
Proceed with system configuration
via HMI as explained in user manual
System parameter configuration must be
performed before unit is turned on!
Summary of Contents for GTIB-30
