Getting Started
Loading the Paper Roll
Attaching The Belt Loop System
The belt loop system consists of two parts:
•
A knob located on the back part of the printer just above the battery door
•
A belt loop strap with a click on connector
After sliding your belt through the strap of the belt loop:
•
Insert the knob located on the bottom of the printer into the slot of the belt loop connector.
•
Pull down on the printer until you hear a click. The printer is now secure and can safely hang down
beside your hip.
•
To release the printer, press in on the two latches on the sides of the connector and pull the printer and
knob up and clear of the slot.
Note:
Do not force or pull the printer from the connector without pressing in on the two latches.
6
