160
Chapter
4
LinePrinter Plus Emulation (With PCL-II)
Character Set
Specifies a character set as shown in the “Proprinter XL Character Sets
Menu” on page 161. To use one of these sets, choose the desired group
heading (such as European Sets) and press ENTER. Then choose the
desired set within that group (such as Roman 8) and press ENTER. Both the
group and the desired set will be starred to indicate your selection. The UTF-8
selection allows printing of UTF-8 encoded Unicode ™. Character sets are
shown in detail in the
Character Sets Reference Manual
.
Alt. Char Set
This option determines if data in the range of hex 80 through hex 9F should
be interpreted as a control code or as a printable character.
•
Set 1
(default). Interprets data in the range of hex 80 through hex 9F as a
control code.
•
Set 2
. Prints data for the characters at hex locations 03, 04, 05, 06, 15,
and 80 through 9F.
20 CPI Condensed
Compressed print characters are narrower than the normal character set.
This is helpful for applications where you need to print the maximum amount
of information on a page.
•
Enable
(default). Prints characters about 60 percent the width of normal
characters when compressed print is chosen by the host computer.
•
Disable
. Does not compress print widths, even if condensed print is
chosen by the host.
Summary of Contents for P7002H
