280420 FGA-330
- Owner’s Manual
Rev: 11/18/12
Page: 8
Assembly Instructions:
4. Using push handle, lift the Mast with Boom assembly upright, and drop carefully into the base tube as
shown in Figure 5, 6, and 7.
5. Using mast locking handles, secure the lift mast in the upright position on the base assembly as shown in
Figure 8. Tighten the mast locking knob as shown in Figure 9. Adjust the position of the locking handles
pointing in downward direction towards the base of lift (or ground) as shown in Figure 9.
Figure 5
Figure 9
Figure 8
Mast Locking Handles
Caution: Possible finger trap. Keep fingers away from the end of the mast when inserting
into the base tube.
Figure 6
Figure 7
