280420 FGA-330
- Owner’s Manual
Rev: 11/18/12
Page: 12
Assembly Instructions:
13. Connect all the cables to the control box as shown in the picture below.
A. Connect the Hand Control connector to the large circle on the left side of the control box as shown in
the Figure 23.
B. Connect the Up/down Actuator Cable connector to the second circle (Marked No. 1) from the left side
of the control box as shown in the Figure 24.
C. Connect the Mains Cable/Power Cord to the rectangular outlet on the control box as shown in the Figure
25.
14.
Please make sure to charge battery before initial use and before each operation of floor lift.
Figure 23
Figure 23
Figure 24
Figure 25
After assembly, check to ensure that:
1. Legs are fully engaged, and leg locking knob is flush with base tube.
2. The mast is fully locked into position.
3. The RED emergency stop button on control box is in the OFF (out) position.
4. Lifting actuator moving up and down with the buttons on the hand control, and control box.
5. Emergency lowering (mechanical, and electrical) function works properly.
6. Rear wheel brakes works properly.
7. Leg spreading foot pedal works properly.
8. Battery is fully charged.
