9
prismatibro.se | Prisma Light
DEPLOYMENT AND USE
Prisma Light DALI
• With a DALI-driver it is possible to change the power output later on as
well as the night reduction.
The adjustments can be made in different ways.
Alternative 1
You go all the way up to the luminaire that is mounted
on the pole and you make the adjustments close to the driver.
Alternative 2
You buy the luminaire with a 5-wired cable, then you
can make the adjusments down at the access point in the pole.
Prisma Light Remote
INSTALLATION
• Power on to the luminaire.
• Prisma Light Elton should now have
the factory setting that the customer
wanted when ordered.
• Prisma Light Elton has a PCB with
built in IR-communication.
Prisma
USE
• The settings are changed
with a remote control.
Manual can be downloaded from:
www.prismatibro.se
Prisma Light Detect
INSTALLATION
• Power on the luminaire
When it starts up the luminaire will blink as it calibrates it’s self.
Before it is programmed by the customer -see installation manual control systems
- the luminaire will be att 40% when there is no detection and 50% at detection.
At this stage it doesn’t communicate with other luminaries.
Prisma Light Nema
Turn on the power.
The luminaire is delivered with maximum power output from
the driver, which later can be adjusted with the customers own Nema-control.
Alternatively, tell us the settings that should apply before you
connect your Nema-control and we will make those settings at
the factory.
Prisma Light SR
Turn on the power.
The luminaire is delivered with maximum
power output from the driver, which later can be adjusted with
the customers own SR-control. Alternatively, tell us the settings
that should apply before you connect your SR-control and we
will make those settings at the factory.
CONTROL SYSTEMS
MANUAL
