5 -
PRM 60
IDENTIFICATION PLATE INFORMATION
Every PRM gearbox is fitted with an identification plate on the top half of the gearcase before it leaves the factory;
an example of such a plate is shown below.
Please complete the above box with serial number and specification of your own gearbox.
It will be noted that there are two lines of numbers.
The top line is the gearbox serial number, and should always be quoted when ordering spare parts; the lower line is the
gearbox specification, in the example given this translates as follows:-
60
D
2
First 2 digits
– Gearbox Model (60)
Third digit
– Output Shaft configuration
Fourth/fifth digit
– Ratio
NOTE: Throughout this manual, engine, gearbox and propeller rotation are always described as seen looking
forward from the propeller to the engine.
SERIAL NUMBER
WORKS ORDER NUMBER
GEARBOX
MODEL
OUTPUT SHAFT
CONFIGURATION
VXXXXX
WXXXXX
D
60
2
RATIO
Figure 1 - Example of Serial Plate
Figure 2 - Blank Serial Plate
Summary of Contents for PRM 60
