SPEEDY F1 usage instructions
12
Figure 4: Backrest adjustable and foldable (view
from outside of product)
Figure 5: Locking pin and stop pin (viewed from the
outside of the product)
Figure 6: Locking pin connected to the cord (bottom
view)
Figure 7: Cord for operating the locking pin and thus
for adjusting the angle of the backrest
If you have released both locking pins by pull-
ing on the cord, you can adjust the backrest as
desired and re-engage it by letting go of the
cord. In doing so, before applying load again,
make sure that both locking pins have en-
gaged safely into the desired locking holes (the
same position on the right and left).
Depending on the adjustment of the
backrest angle, check the tight engagement of
the backrest via the locking pins.
To
fold down the backrest
, pull on the middle
of the cord towards the front, and at the same
time, fold the backrest downwards until it rests
on the seating area. If you want to return the
backrest to the desired angle, proceed as de-
scribed at the beginning of backrest angle
adjustment.
Video
Adjustment of the backrest an-
gle & folding:
https://www.youtube.com/watch?v=rXdDUbi
nJW4
17.2 Adjustable back & its adjustment
options
The "adjustable back and back padding" back
system consists of a belt system and back
padding. The slack of the backrest can be
adapted to the individual requirements via the
belts with tensioning loops.
First remove the back padding that has been
covered over which has been attached using
hook-and-loop straps. The belt system located
underneath has been set in the factory that the
top and the bottom belts have a slack of ap-
prox. 2 cm. The middle belts have been pulled
tight for a good lumbar support.
Cord
Locking pin
Pull from
the middle
to the front
Locking pin
Stop pin
![Dietz AS[01] Operating Instructions Manual preview](http://thumbs.mh-extra.com/thumbs/dietz/as-01/as-01_operating-instructions-manual_2495921-01.webp)
