Usage instructions for SPEEDY F1
23
Figure 49: Foot support with "Box shape" footrest
from below
21.2 Footrest continuous
Figure 50: Foot support with footplate "Tipped for-
ward" throughout
Figure 51: Foot support with "Box shape" footplate
throughout
For the
longitudinal setting of the footrest
support tubes or adaptation to the lower leg
length
, the M6 fixing screws (AF 4 mm) must
be undone on both sides on the outside of the
frame tube. The footrest support tubes are
then pushed along their slots and thus brought
into the correct position. Observe that the foot-
rest support tubes are both the same length on
both sides after they have been adjusted.
Figure 52: M6 fixing screw with washer and slot
infootrest support tube for adjusting the lower leg
length
Once the position has been set, fix the footrest
support tubes by tightening the M6 fixing
screws (AF 4 mm) with washers to 11 Nm on
both sides.
Ensure when setting the lower leg length,
that no strong pressure is produced between
the underneath of the lower leg of the wheel-
chair user and the edge of the seating system.
Note:
With a product frame or with a larger lower leg
width at the top than the bottom, it is necessary
to relieve the footrest support tube tension in
the footrest support plate resulting from longi-
tudinal adjustment. In this case, the M6 fas-
tening clamp screws (AF 5 mm) on the footrest
support plate therefore have to be opened
before starting to adjust the lower leg length.
View the procedure in chapter 21.1.
M6 fixing screw
with washer
Footplate support
Footrest
support plate
M6 fastening
clamp screws
Slots in the
support tube
