SPEEDY F1 usage instructions
30
2. Bags and other objects not belonging to
the product which are on or in the product,
must be removed and securely stowed.
3. Secure the product with lashing straps. To
do this, use the existing securing devices
in the vehicle. After securing, the product
may not roll, slip or tip over to the side any
more.
The tensioning straps used to fasten the
product securely in the transport vehicle must
only be attached to the motor vehicle compo-
nents intended for that purpose and to the
frame of the product.
Do not transport the product on the front
passenger seat. The product could slip and
impede the driver.
25.4 Passenger transport over obsta-
cles in the product
If the product with its user needs to be
transported over an obstacle and there are
suitable facilities such as a ramp or a lift avail-
able, then these should be used. If such facili-
ties are not available, then the obstacle is to be
overcome by being carried by two helpers.
When carrying the product, it may not
be lifted
by the side sections, the drive wheels or the
footrests. PRO ACTIV recommends holding
the product by the frame and the back cross
bar to carry it.
26 Malfunctions
In the event of any malfunctions which cannot
be repaired by yourself based on the usage
instructions included in the scope of delivery,
please contact your rehabilitation specialist
dealer or PRO ACTIV directly.
Malfunctions must be repaired before any
further use or, if they occur during the trip, it
must be interrupted immediately.
All serious incidents that have occurred in con-
nection with the product must be reported to
the manufacturer and the responsible authority
in the state in which the user resides.
27 Cleaning and care
Regularly cleaning the product is prescribed to
prevent the components from becoming stiff
due to soiling. In particular, the product should
be carefully cleaned after every major use.
To avoid corrosion and therefore malfunctions
or breakages of components, the product may
not be exposed to any aggressive environmen-
tal influences. If this cannot be avoided, the
product must always be cleaned immediately
after such use, and moving parts must be
greased. Regular cleaning prevents corrosion
and increased wear.
In case the product becomes wet when using,
dry it after use.
Clean the quick release axles of the drive
and caster wheels as well as the ball bearings
and grease these with a little lubricating oil with
high corrosion protection properties (e.g. Ne-
oval MTO 300) approx. every 8 weeks in order
to guarantee the reliable functioning properties.
Clean your product with water, solvent or
neutral cleaning agents. Do not use any abra-
sive cleaning agents or aggressive, acidic
cleaners, to prevent scratching or fading of the
coating or the anodised parts. Only use water
and soap to clean the seat and backrest up-
holstery.
The product must not be cleaned using
steam or high pressure.
Recommended care:
If you need care products for your product,
please contact PRO ACTIV.
28 Maintenance
28.1 General instructions
The product is not a maintenance-free device.
Therefore, please observe the following in-
structions about maintenance.
