For further information on RZR Door Installations and Warnings please visit our website
WW W.PR OARM OR.C OM
or
Contact customer service at
1-888-31-ARMOR
Installatio n Instr uctions:
1. Make sure the stock doors are tight and fitment is good. The door must open and close with no issues.
2. Place the supplied adhesive rubber pads to the areas shown on the figure to the bottom right. Place them on the outer most flat surface
area to aid in a quiet and solid mounting area.
3.
Remove the top 2 hinge bolts and the upper panel bolt like shown in the figure on the bottom left.
4. Set the door panel over the stock door like shown below and tighten the bolts back up, so they mount the Aluminum panel to the stock
door.
Make sure the panel lines up evenly with the plastic trim surrounding it. Also make sure the weather stripping makes a tight seal
when the door is in the closed position.
5. Use a drill and 1/4” drill bit, then drill our your stock plastic door and use the supplied M6 Flange bolt and Cap nut to secure the panel to
the bottom of the stock door.
Rubber Adhesive Pads
6
. Repeat for both sides.
•
Due to the production variances and differing conditions of the frame, door adjustments may be necessary to avoid rubbing
and proper fit Ensure proper fit before tightening hardware and continuing with installation!
NOTICE
Due to the production variances and differing conditions of the frame, door adjustments may be necessary to avoid rubbing and proper fit En-
sure proper fit before tightening hardware and continuing with installation! If adjustment is necessary, confirm all mounting points are secured
Remove these bolts and
install door on these.