46
Eng
lis
h
USB Cable Clamp
USB Cable Clamp
When using a USB device, attach a USB cable clamp to the USB interface to
prevent the USB cable from being disconnected.
1. Attaching the USB Cable Clamp
Note:
Watch your fingers. The edge of the clip is sharp.
WARNING
RECOMMENDATION FOR RESTRICTED AREAS
• Verify the power, input, and output (I/O) wiring are in accordance with
Class I, Division 2 wiring methods.
• Substitution of any component may impair suitability for Class I, Division 2.
• Confirm that the USB cable has been fixed with the USB cable clamp
before using the USB interface.
• Remove power before attaching or detaching any connectors to or from the
unit.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
Step
Action
1
Mount the clip to the USB mark
connector shell so that it
overlaps. The clip matches the 27 to 43.5 mm [1.06 to 1.71 in]
length of the USB connector.
2
Align the clip and the USB cable connector shell. Adjust the
position of the holes where the clip is attached. To ensure stability,
select the clip-hole position that is closest to the base of the
connector shell.
27 to 43.5mm
[1.06 to 1.71 in.]
Pass the tie
through here.
