3 - 8
PL-6700 Series User’s Manual
Optional Units and Expansion Boards
5) Reattach the connection cable to
the PL-HD100’s connector (See
note below).
4) Detach the PL-HD000’s connection
cable from the unit.
6) Secure the HDD unit in place with
its 2 attachment screws.
7) Fold the HDD’s cable so that it
looks like the picture, and insert
the folded cable’s end into the
HDD’s holder slot.
• Be sure that the cable is not
pinched by either the PL’s
chassis or the attachment
screws.
PL- HD000
Attach the Main
Board connector
carefully
Connect to the
PL-HD100
HDD Connector
Cable
• Be sure not to bend any of
the HDD’s connector pins
while removing the cable’s
connector.
Do not use
these pins
<Figure 1 ‑ PL‑HD100 Connector>
<Figure 1 ‑ PL‑HD100 Connector>
<Figure 1 ‑ PL‑HD100 Connector>
<Figure 1 ‑ PL‑HD100 Connector>
<Figure 1 ‑ PL‑HD100 Connector>
Cable Inversion Prevention Pin (Removed)
Connect the
cable here
Important
!!!!!
If the hard disk unit’s connector is attached incorrectly, there is a possibility of damage to the unit.
Please follow the instructions given here carefully.
X
X
Be sure the hard disk unit cable’s main board connector is not skewed from its correct attachment
position (see above examples). Incorrect attachment can cause damage to the unit.
Summary of Contents for PL-6700 Series
