2 - 1
PL-6700 Series User’s Manual
2-1 General Specifications
2-2 Performance Specifications
2-3 Interface Specifications
2
Environment Specifications
1
Electrical Specifications
Operating Voltage
85V AC to 132VAC / 170V AC to 265V AC 50/60 Hz
Power Consumption
Less than 150W
Allowable Voltage
Drop
less than 20ms
Voltage Endurance
1500V AC at 20mA for 1 minute (between the live wire and the
grounding (FG) terminal)
Isolation Resistance
Greater than 10M
Ω
at 500V DC (between the live wire and the
grounding (FG) terminal)
Operating
Temperature
5 to 40
o
C (with HDD and FDD not installed, 0 to 40
o
C)
Operating Humidity
30 to 85% RH (no condensation)
Storage Conditions
-10 to 60
o
C/ 30 to 85% RH (no condensation)
Operating
Atmosphere
Free of corrosive gas
Noise Immunity
(via noise simulator)
Noise Voltage: 1500Vp-p
Pulse Duration: 50ns, 500ns, 1
µ
s
Electrostatic Voltage
Endurance
4kV
Vibration Endurance
2G: 10 to 25Hz applied in X, Y, and Z directions for 30 minutes each
(0.5G when using HDD unit, 1.0G when using FDD)
Rating
*1
(with front panel closed)
Equivalent to IP65f (JEM1030)
2-1 General Specifications
2-4 PL External Features
2-5 PL Dimensions
Chapter
2
Specifications
*1 The front face of the GP unit, installed in a solid panel, has been tested using conditions equivalent to the
standard shown in the specification . Even though the GP unit’s level of resistance is equivalent to the
standard, oils that should have no effect on the GP can possibly harm the unit. This can occur in areas where
either vaporized oils are present, or where low viscosity cutting oils are allowed to adhere to the unit for long
periods of time. If the GP’s front face protection sheet becomes peeled off, these conditions can lead to the
ingress of oil into the GP and separate protection measures are suggested. Also, if non-approved oils are
present, it may cause deformation or corrosion of the front panel’s plastic cover. Therefore, prior to installing
the GP be sure to confirm the type of conditions that will be present in the GP’s operating environment.
If the installation gasket is used for a long period of time, or if the unit and its gasket are removed from the
panel, the original level of the protection cannot be guaranteed. To maintain the original protection level,
you need to replace the installation gasket regularly.
Summary of Contents for PL-6700 Series
