9
Environmental
Structural
*1 The front face of the PS-G unit, installed in a solid panel, has been tested using
conditions equivalent to the standards shown in the specification. Even though the PS-G
unit’s level of resistance is equivalent to these standards, oils that should have no effect
on the PS-G can possibly harm the unit. This can occur in areas where either vaporized
oils are present, or where low viscosity cutting oils are allowed to adhere to the unit for
long periods of time. If the PS-G’s front face protection sheet becomes peeled off, these
conditions can lead to the ingress of oil into the PS-G and separate protection measures
are suggested. Also, if non-approved oils are present, it may cause deformation or
corrosion of the front panel’s plastic cover. Therefore, prior to installing the PS-G be
sure to confirm the type of conditions that will be present in the PS-G’s operating
environment.
If the installation gasket is used for a long period of time, or if the unit and its gasket are
removed from the panel, the original level of the protection cannot be guaranteed. To
maintain the original protection level, be sure to replace the installation gasket regularly.
Physical
Ambient Operating
Temperature
0°C to 50°C
Storage
Temperature
-10°C to +60°C
Ambient Humidity
10%RH to 90%RH
(Wet bulb temperature: 39°C max. - no condensation.)
Storage Humidity
10%RH to 90%RH
(Wet bulb temperature: 39°C max. - no condensation.)
Dust
0.1mg/m
3
max. (non-cpnductive levels)
Pollution Degree
Pollution Degree 2
Atmosphere
Free of corrosive gases
Mechanical Vibration
Resistance
IEC61131-2(JIS B 3502) compliant
5Hz to 9Hz Single amplitude 3.5mm
9Hz to 150Hz Fixed acceleration 9.8m/s
2
X,Y,Z directions for 10 times (100min.)
Electrical
Noise Immunity (via
noise simulator)
Noise Voltage: 1,500Vp-p
Pulse Duration: 50ns, 500ns, 1µs
Rise Time: 1ns
Electrostatic
Discharge Immunity
6kV (complies with EN 61000-4-2 Level 3)
Installation
Grounding
Grounding resistance of 100
Ω
, 2mm
2
[0.0062inch
2
] or
thicker wire, or your country’s applicable standard.
(Same for FG and SG terminals)
Structure
Rating
*1
: Equivalent to IP65f
Installation method: Panel/VESA Arm
Cooling Method
Natural air circulation
Weight
Approx. 3.5kg [7.7lb.] (unit only)
External
Dimensions
W313mm [12.32in.] x H239mm [9.41in.] x D56mm [2.20in.]
