20
This clamp is used to prevent the USB cable connected to the USB Host Interface on the
bottom of the PS-G unit from being unplugged due to vibration or other causes.
Attachment
As shown below, insert the USB Cable Clamp’s band through the Bridge. Pass the USB
cables through the Cable Clamp’s band and securely tighten the clamp band around the
cables.
Removal
To remove the clamp from the USB cables, push down on the clamp strap’s clip to release it
while pulling up on the clamp.
Peripheral Devices Installation
1
USB Cable Clamp Attachment/Removal
• Be sure the clamp is securely holding the USB cable’s plug and collar.
• Be sure the clamp is positioned as shown below, with the clamp
pointing upwards - not to the side. This is to keep the clamp from
interfering with nearby connectors and their cables.
Cable Collars
Band
Clamp
Bridge
USB Cable
Clamp
Clip
