PS-3710A/PS-3711A Series Hardware Manual
4-12
(9)
Secure both backlights in place using the backlight screw (opposite of step (4)). The necessary torque is
0.147N•m.
(10) Replace the rear cover and secure it in place using the eight (8) attachment screws.
The necessary torque of the rear cover is 0.5N•m to 0.6N•m.
• Be sure the cable is inserted completely into the backlight connector. Failure to
do so may cause arcing, which can damage the connector.
• Be sure to always change both of the PS-A backlights at the same time.
SEE
3.2.1 Removal/Attachment the Rear Cover (page 3-6)
For PS-3711A Series (page 3-7)
• The cable clamp is used to prevent the cable from being caught inside in the PS-
A unit and possibly damaged. Be sure to insert the cable in the cable clamp
before replacing the rear cover.
