PS-3710A/PS-3711A Series Hardware Manual
2-30
Switches
The following switch settings corresponding to each Serial Interface need to be signified. To set the switches
which are on the PS-A’s circuit board, remove the PS-A’s Rear Cover. Please refer to 3.2.1 Removal/
Attachment the Rear Cover (page 3-6). The switches are located as follows;
Switch
Location
Switch Name
Compatible
I/F
Factory
Settings
Description
A
Serial Mode Select SW
COM2
All OFF
(RS-232C)
10-point dip switch. Designates COM2
communication settings. For Serial Mode
Select SW details, see Table (2).
B
System Set SW
-
See
Table (1)
10-point dip switch. For System Set SW and
the factory settings details, see Table (1).
C
RI/+5V Changeover SW
COM1
RI
Changes # 9 pin (RI <---> +5V).
10
10
ON
123456789
123456789
B
C
Inside of the rear
