Chapter 3 Installation and Wiring
3-15
When attaching the HDD/SSD to the PS-3711A
(1)
Place the PS-A unit face down and unscrew eight (8)
attachment screws (See diagram).
(2)
Lift the PS-A unit’s Rear Cover off of the PS-A unit.
(3)
Insert the HDD/SSD unit cable connector completely
into the IDE I/F. Attach the HDD/SSD unit using four (4)
attachment screws. The torque should be 0.5 to 0.6 N
•
m.
(4)
Replace the PS-A unit’s Rear Cover and reattach eight
(8) attachment screws. The torque should be 0.5 to 0.6
N
•
m.
•
As for AC Power Supply type, remove the
power cover as shown below.
•
As for AC Power Supply type, replace the power
cover and reattach the screws.
PS-A unit’s Rear Cover
IDE I/F
AC Power Supply type
Power Cover
