A-3
Appendices
1.3 Structural
*1 The front face of the PS-G unit, when installed in a solid panel, has been tested using
conditions equivalent to the standards shown in the specification. Even though the PS-G
unit’s level of resistance is equivalent to these standards, oils that should have no effect on
the PS-G can possibly harm the unit. This can occur in areas where either vaporized oils are
present, or where low viscosity cutting oils are allowed to adhere to the unit for long periods
of time. If the PS-G’s front face protection sheet becomes peeled off, these conditions can
lead to the ingress of oil into the PS-G and separate protection measures are suggested. Also,
if non-approved oils are present, it may cause deformation or corrosion of the front panel’s
plastic cover. Therefore, prior to installing the PS-G be sure to confirm the type of conditions
that will be present in the PS-G’s operating environment.
If the installation gasket is used for a long period of time, or if the unit and its gasket are
removed from the panel, the original level of the protection cannot be guaranteed. To
maintain the original protection level, you need to replace the installation gasket regularly.
Grounding
100
.
or less, or your country’s applicable standard
Ratings*1
(Front face of installed unit)
Equivalent to IP65f (JEM 1030)
Design Type: Modular
Installation method: panel mounting
Cooling Method
Natural air circulation
Weight
Approx. 1.7kg (3.7Ib)
Dimensions (W
⋅
H
⋅
D)
215 mm [8.46 in]
⋅
170 mm [6.69 in.]
⋅
60 mm [2.36 in.]
