3-11
3 Start Up and Shut Down
3)
Perform a backup and save the settings to the CF Card.
After restarting the PS-G unit, be sure to check the current settings via
the [Network Configuration] dialog box’s Built-In Controller tab’s data.
3
Internal Application
This section explains each of the PS-G unit’s internal applications.
3.1
Version Information
Psgver.exe
This application will call up the PS-G unit’s version information. It is located in the [Windows]
folder.
3.2
Auto Start
AutoRun.exe
The application saved in the CF card can be automatically started when the PS-G unit is turned
ON. The following explanation describes this procedure.
(1) Create a shortcut in the [\Windows\Startup] folder pointing to [AutoRun.exe] in the PS-G
unit’s [\Windows] folder.
(2) Open the Properties of the shortcut created in step (1), open the [Shortcut] tab and set the
application to run automatically by changing the link destination in the “Target” field as
follows.
Target: “\Windows\AutoRun.exe” “\Storage Card1\Application name”
