4-4
PS-400G Series User Manual
4)
Insert the gasket in the remaining corners.
5)
Check that the gasket is fitted properly.
• If the gasket is not inserted correctly into the groove, it will not provide a
level of water resistance equivalent to IP65f.
• The gasket must uniformly extend approximately 2 mm out of the groove.
Always check that the gasket is fitted correctly before installing the PS-G
unit.
3.2 Replacing the Backlight
The backlight is a long-life product. The average life of the backlight (the time for brightness to
fall to half its normal level) is 50,000 hours in an environment with an ambient temperature of
25°C. Replace the backlight when necessary.
The replacement backlight model number is PS400-BU00-MS.
• Use of any other model of backlight may result in an accident or a PS-G
unit breakdown.
• For backlight replacement information, refer to the replacement
backlight’s installation guide (replacement backlights are sold
separately).
2mm
