5-3
5 Troubleshooting
1.1 No display (Windows CE does not start)
1.2 Touch panel does not respond
Step
Check Item or Operation
Check result
Action required
1
Has the touch panel been calibrated?
Calibrate the touch panel.
Refer to “Chapter 3 2.2 Control Panel
Settings”.
Touch panel cannot be calibrated -> <H>
Was the problem solved by the above
action?
No -> <H>
Step
Check Item or Operation
Check result
Action required
1
2
Is the power cord connected
correctly?
Connect the power cord correctly.
Refer to “Chapter 2 2 Power Connections”
3
Is the power supply voltage within
specifications?
Refer to “Appendix 1 Specifications”
4
Is the first Dip Switch inside the CF
card set to ON, and the second
through fourth Dip Switches to OFF?
Set the first Dip Switch to ON, and the second
through fourth Dip Switches to OFF.
Refer to “Chapter 3 2.1 Dip Switch Settings”
5
6
Does the power indicator light up?
Power indicator does not light up -> <H>
7
Does the power indicator change from
red to green after the sounding of a
short buzzer?
Does not change to green.
Buzzer sounding continuously -> No startup
disk
-> <H>
8
Is the backlight on?
If the backlight has burned out, replace it.
Refer to “Chapter 4 3.2 Replacing the
Backlight”
Was the problem solved by the above
actions?
No -> <H>
Turn the PS-G unit’s power supply OFF.
Turn the power supply ON.
