E-14
10
Replacing the Backlight
9
Input/Output Signal Line Cautions
•
Input and Output signal lines must be separated from the power control
cables for operational circuits.
•
If this is not possible, use a shielded cable and the shield should be
grounded.
•
The PS-G unit's backlight is user replacable.
For an explanation of how to replace the PS-G unit's backlight, please refer
to the instruction manual which comes with the replacement backlights
(sold separately).
•
Be sure to use backlight model PS600-BU00.
Using any backlight other than the model written above may
cause an accident or PS-G unit malfunction.
Note
Be aware that the Digital Electronics Corporation shall not be held liable for any real or
estimated damages or losses, or third party claims resulting from the use of this product.
© 2001 Digital Electronics Corp.
