7
4. Identify the Right Upright (72) and the Right
Upright Spacer (74), which are marked with
“Right” stickers. Insert the Upright Wire (78)
through the Right Upright Spacer as shown. Set
the Right Upright Spacer on the Base (80).
With the help of a second person, hold the Right
Upright (72) near the Base (80).
See the inset
drawing.
Tie the wire tie in the Right Upright se-
curely around the end of the Upright Wire (78).
Then, pull the other end of the wire tie until the
Upright Wire is routed completely through the
Right Upright.
3. Attach a Base Wheel (81) with the 3/8" x 2" Bolt
(4) and the 3/8" Nut (8) that you removed in step
1.
Do not overtighten the Nut; the Base
Wheel must turn freely.
4
8
3
81
80
78
72
74
78
4
Wire
Tie
72
78
Wire Tie
2. With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (53) so that the treadmill is more stable;
do not fully fold the Frame yet.
Remove and discard the two indicated bolts (A)
and the shipping bracket (B).
Cut the shipping tie securing the Upright Wire
(78) to the Base (80). Locate a plastic tie in the
indicated hole in the Base, and use the tie to pull
the Upright Wire out of the hole.
Attach a Base Foot (79) to the Base (80) in the
location shown with a Base Foot Spacer (25)
and a 1" Tek Screw (56). Then, attach another
Base Foot (79) with only a 1" Tek Screw (56).
80
56
53
79
2
79
56
78
Hole
25
A
B
