7
1.
Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (55) so that the treadmill is more stable;
do not fully fold the Frame yet.
Locate the Upright Wire (85), which is bundled
at the back of the Base (94). Remove the pack-
aging from the Upright Wire. Next, insert the
Upright Wire into the Base, and pull it out of the
indicated hole. If necessary, use the plastic tie to
pull the Upright Wire out of the hole.
Next, hold a Wheel (95) inside of a Wheel
Housing (96). Insert a Wheel Axle (97) into the
Wheel, and press the Wheel Housing into the
Base (94).
Make sure that the tab on the
Wheel Housing is in the position shown.
Attach the other Wheel (95) in the same way.
97
95
95
96
Tab
1
94
55
85
2. Attach the four Base Feet (92) to the Base (94)
in the locations shown with four #8 x 1" Tek
Screws (2).
See the inset drawing.
Cut the plastic tie near
the Upright Wire (85).
2
94
2
92
92
2
2
2
92
92
85
Hole
Tie
Cut
85
Tie
Tie
