12
15.
Make sure that all parts are properly tightened before you use the exercise cycle.
Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
13. Plug the Pulse Wire into the Pulse Receptacle
(39) in the Frame (1).
13
14. Identify the Right Pedal (44), which is marked
with an “R.”
Using an adjustable wrench,
firmly tighten
the
Right Pedal (44)
clockwise
into the right side of
the Crank (17). Tighten the Left Pedal (not
shown)
counterclockwise
into the left side of the
Crank.
IMPORTANT: Tighten both pedals as firmly
as possible. After using the exercise cycle
for one week, retighten the pedals.
Adjust the strap on the Right Pedal (44) to the
desired position, and press the ends of the
straps onto the tabs on the Right Pedal.
Adjust
the strap on the Left Pedal (not shown) in
the same way.
14
Pulse
Wire
44
17
39
1
Strap
Tab
