6
3. Refer to HOW TO LOWER THE TREADMILL FOR USE
on page 11. Follow step 2 on page 11 to lower the treadmill.
If there are plastic ties on the Left and Right Handrails (4,
5) in the indicated locations, cut them off.
Position the Left Handrail (4) on the left Upright (37).
With the help of a second person, hold the Right Handrail
(5) and the Console Base (45) near the right Upright (37).
Feed all of the excess Wire Harness (53) down into the
Right Handrail, through the indicated bracket, and down into
the right Upright; bend the Wire Harness, if necessary.
Make sure that the Wire Harness is in the bracket and
insert the bracket into the right Upright. Make sure that
the Wire Harness is not pinched.
5. Attach the Console Base (45) to the Left and Right
Handrails (4, 5) with four Screws (90).
Feed the excess Wire Harness (53) into the upper end of
the Right Handrail (5).
Tighten all parts used in steps 4 and 5.
7. Make sure that all parts are properly tightened before you use the treadmill. To protect the floor or car-
pet, place a mat under the treadmill.
4
90
90
37
53
5
5
45
4. Thread two Handrail Bolts (11) with Handrail Washers
(39) two complete turns into the left Upright (37) and the
Left Handrail (4). Do not tighten the Bolts yet.
Thread two Handrail Bolts (11) with Handrail Washers
(39) two complete turns into the right Upright (37) and the
Right Handrail (5). Do not tighten the Bolts yet.
3
39
37
11
4
39
5
11
39
37
11
11
Batteries
48
Tab
6. The console requires two 1,5 V batteries (included); alka-
line batteries are recommended.
Open the Battery Cover (48) as shown. Press two batter-
ies into the battery compartment, with the negative (–)
ends of the batteries touching the springs. Close the bat-
tery cover, push up on the Battery Cover tab, and then
push the tab forward as shown in the inset drawing. Be
sure that the tab locks into place.
4
6
48
4
45
53
5
Bracket
Plastic
Ties
37
37
