13
The right display
—
When the manual
mode or the 30-minute
Challenge program is
selected, the right dis-
play will show the
speed of the walking belt. When the 5K Run pro-
gram is selected, the display will show the speed of
the walking belt and the approximate number of
calories you have burned.
The right display will also show your heart rate
when you use the pulse sensor (see step 7 below).
To reset the displays, press the Stop button, re-
move the key, and then reinsert the key.
7. Measure your heart rate if desired.
To measure your
heart rate,
stand
on the foot rails
and place your
left thumb on the
pulse sensor.
Do
not press too
hard, or the cir-
culation in your
thumb will be restricted and your pulse will not
be detected.
When your pulse is detected, a heart-
shaped indicator in the right display will flash each
time your heart beats, one or two dashes will ap-
pear, and then your heart rate will be shown.
For
the most accurate heart rate reading, hold your
thumb on the pulse sensor for at least 15 sec-
onds.
If the displayed heart rate appears to be too high or
too low, or if your heart rate is not displayed, lift
your thumb off the pulse sensor for a few seconds.
Then, reposition your thumb on the pulse sensor.
Remember to stand still while measuring your
heart rate.
8. When you are finished exercising, remove the
key.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest setting
when you fold the treadmill to the storage posi-
tion, or you may damage the treadmill.
Next, re-
move the key from the console and put it in a secure
place.
When you are finished using the treadmill, switch
the reset/off circuit breaker to the “off” position and
unplug the power cord.
IMPORTANT: If you do
not do this, the treadmill’s electrical compo-
nents may wear prematurely.
HOW TO USE THE 5K RUN PROGRAM
1. Insert the key into the console.
See HOW TO TURN ON THE POWER on page
11.
2. Select the 5K Run program.
Press the Program
Select button repeatedly
until P1 appears in the
center display and the
right display begins to
flash. Note: If the walking
belt is moving when the Program Select button is
pressed, the walking belt will slow to a stop.
A few seconds after the
5K Run program is se-
lected, the number 5,000
will appear in the center
display.
3. Press the Start button or the Speed increase
button to start the program.
A moment after the button is pressed, the walking
belt will begin to move at 3 miles per hour. Hold the
handrails and begin walking.
Near the end of the first minute of the program, the
right display will flash and a series of tones will
sound. When the first minute is completed, the
speed of the walking belt will increase to 5 miles
per hour.
At the end of the second minute of the program,
the right display will flash, a series of tones will
sound, and the speed of the walking belt will in-
crease to 6.5 miles per hour.
Pulse Sensor
