9
10.
Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the
walking belt (see page 17). To protect the floor or carpet, place a mat under the treadmill.
9. Attach a Wheel (66) to the inner side of each Extension
Leg (63) with a Wheel Bolt (64) and a Wheel Nut (32)
(only one Wheel is shown).
Do not overtighten the
Wheel Bolt. The Wheel should be able to spin freely.
Lift the treadmill frame (see HOW TO FOLD THE
TREADMILL FOR STORAGE on page 14), but do not
latch it. Make sure that the frame is centered between
the Handrails (not shown).
See step 4 and firmly
tighten the 3/4” Bolts (37). Then, lower the frame to the
floor.
63
64
66
32
9
47
42
44
8. Insert the excess Wire Harness (42) into the large hole in
the side of the Right Handrail (72).
Securely tighten the
plastic ties on the bottom of the Console Base (47) to
prevent the Wire Harness from slipping. Then, cut off
the ends of the plastic ties.
Route the Wire Harness (42) through the indicated open-
ing in the Console Base (47), and attach the Wire Cover
(44) to the Console Base with a 1/2” Silver Screw (48).
Do
not overtighten the Silver Screw.
Tighten a Crossbar Screw (39) into the bracket on each
Upright (69) and into the Crossbar (40) (one one Screw is
shown).
8
72
69
48
40
39
Ties
Opening
