ASSEMBLY
Assembly requires two persons.
Set the treadmill in a cleared area and remove all packing materials.
Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, some lubricant may be transferred to the top of
the walking belt or the shipping carton. This is normal and does not affect treadmill performance. If there is lubri-
cant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex keys and your own Phillips screwdriver
, rubber
mallet
, adjustable wrench
, wire cutters
, and needlenose pliers
.
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is
the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses
is the quantity needed for assembly.
Note: Some small parts may have been preassembled. To avoid dam-
aging parts, do not use power tools for assembly. Extra hardware may be included.
#8 x 3/4"
Screw (2)–4
3/8" Flat Washer
(33)–2
#8 x 1/2" Ground
Screw (27)–2
Wheel Spacer
(44)–4
1/4" Star
Washer
(21)–2
3/8" Nut (47)–6
3/8" Star
Washer
(39)–4
5/16" Star
Washer
(19)–4
3/8" x 2" Bolt (86)–2
1/4" x 1/2"
Bolt (22)–2
5/16" x 2 1/4" Bolt (20)–4
3/8" x 2 1/4" Bolt (5)–6
3/8" x 2 1/2" Bolt (32)–2
1. Orient the Base (48) as shown.
Identify the Right Upright (36), which has a
square hole near the lower end.
Orient the Right Upright (36) as shown, and
attach it to the Base (48) with two 3/8" x 2 1/4"
Bolts (5) and two 3/8" Star Washers (39);
do
not tighten the Bolts yet.
48
Square
Hole
5
5
39
39
36
1
6
