22
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. Before you adjust
the reed switch, unplug the power adapter.
Note: For clarity, the left pedal is shown removed in
the drawing below.
Using a small
standard screw-
driver, carefully
pry the left Crank
Cover (25) off
the left Shield
Cover (24). Next,
remove the two
M5 x 20mm
Screws (53).
Then, rotate the
left Shield Cover
out of the way.
Note: For clarity, the left shield cover is shown
removed in the drawing at the right.
Locate the Reed Switch (35). Rotate the Left Crank
Arm (100) until a Magnet (39) is aligned with the Reed
Switch. Next, loosen the Clamp Screw (A), slide the
Reed Switch slightly toward or away from the Magnet,
and then retighten the Clamp Screw.
Plug in the power adapter and rotate the Left Crank
Arm (100) for a moment. Repeat these actions until the
console displays correct feedback.
When the reed switch is correctly adjusted, reattach
the parts that you removed.
25
53
24
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION: To assure continued compliance, use only shielded interface cables when connecting to
computer or peripheral devices. Changes or modifications not expressly approved by the party respon-
sible for compliance could void the user’s authority to operate this equipment.
IMPORTANT: To satisfy exposure compliance requirements, the antenna and transmitter in the console
must be at least 8 in. (20 cm) from all persons and must not be near or connected to any other antenna or
transmitter.
Note: The console contains FCC ID: OMCBMD1.
39
100
A
35
