7. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet,
place a mat under the treadmill.
5. Place the Console Base (46) on the tubes on the Uprights
(11). Pull out the two Wires (21) just enough to connect
them to the two connectors in the Console Base. Make a
loop with the indicated plastic tie and insert the end
through the tie holder on the bottom of the Console Base.
Plug the Wire that has a red connector into the corre-
sponding connector in the Console Base. The connectors
should fit together without being forced; if they do not, ro-
tate the red connector on the Wire and try again. Do not
force the connectors together. Next, plug the other
Wire into the other connector on the Console Base.
Important: Make sure that both Wires are fully in-
serted. WARNING: Do not disconnect or connect the
Wires while the treadmill power cord is plugged in. Pull
the plastic tie tight and cut off the end.
Refer to drawing 5b. Thread six Console Screws (99) into
the Uprights (11) and the Console Base (46). After all six
Console Screws have been started, tighten the Screws
until they are snug; do not overtighten the Screws.
46
11
11
99
99
11
46
21
21
5a
5b
6. Attach the Storage Latch (14) to the left Upright (11) with
two Small Screws (13). Be careful not to overtighten
the Latch Screws.
13
14
11
6
Tie
11
4
6
3. Remove the Handrail Screw (53) from one of the
Handrails (1). Insert the Handrail into the tube at the top
of the left Upright (11), and align the hole in the Handrail
with the slotted hole in the Upright. Loosely thread the
Handrail Screw into the Handrail, rotate the Handrail until
the Screw is touching one end of the slotted hole, and
then fully tighten the Screw.
Attach the other Handrail (1) to the right Upright (11) in
the same way.
4. There may be a plastic tie in the tube on the right Upright
(11). If there is, do not remove the tie.
11
1
53
53
1
3
Slotted
Hole
Tie
