Pro-Form 5.0 ZLT PETL59815.1, User Manual

18

MAINTENANCE

Regularly clean the treadmill and keep the walking 

belt clean and dry. First, 

press the power switch into 

the off position and unplug the power cord. 

Wipe 

exterior parts of the treadmill with a damp cloth and 

a small amount of mild soap. 

IMPORTANT: Do not 

spray liquids directly onto the treadmill. To avoid 

damage to the console, keep liquids away from the 

console.

 Then, thoroughly dry the treadmill with a soft 

towel.

TROUBLESHOOTING

Most treadmill problems can be solved by follow-

ing the simple steps below. Find the symptom that 

applies, and follow the steps listed. If further assis-

tance is needed, see the front cover of this manual. 

SYMPTOM: The power does not turn on

a.     Make sure that the power cord is plugged into 

a properly earthed outlet (see page 11). If an 

extention cord is needed, use only a 3-conductor, 

14-gauge (1 mm

2

) cord that is no longer than 5 ft. 

(1.5 m).

b.   After the power cord has been plugged in, make 

sure that the key is inserted into the console.

c.   Check the power switch located on the treadmill 

frame near the power cord. If the switch protrudes 

as shown, the switch has tripped. To reset the 

power switch, wait for five minutes and then press 

the switch back in.

SYMPTOM: The power turns off during use

a.   Check the power switch (see drawing c at the left). 

If the switch has tripped, wait for five minutes and 

then press the switch back in.

b.   Make sure that the power cord is plugged in. If the 

power cord is plugged in, unplug it, wait for five 

minutes, and then plug it back in.

c.   Remove the key from the console, and then  

reinsert it.

d.   If the treadmill still will not run, please see the front 

cover of this manual.

SYMPTOM: the displays of the console do not 

function properly

a.   Remove the key from the console and 

UNPLUG 

THE POWER CORD.

 Place the treadmill in 

the storage position (see HOW TO FOLD THE 

TREADMILL on page 17).

   Remove the six indicated M4.2 x 13mm Washer 

Head Screws (5) and the six Foot Rail Flat 

Washers (25). Next, lower the Frame (50) (see 

HOW TO LOWER THE TREADMILL FOR USE on 

page 17).

MAINTENANCE AND TROUBLESHOOTING

Reset

Tripped

c

5

5

5

50

5

25

25

a