8
5. The Console (4) can be operated with four 1.5V
“D” batteries (not included); alkaline batteries are
recommended.
IMPORTANT: If the elliptical
exerciser has been exposed to cold tempera-
tures, allow it to warm to room temperature
before inserting batteries into the Console. If
you do not do this, the console displays or
other electronic components may become
damaged.
Remove the two screws from the
back of the console, and remove the battery
cover. Insert four batteries into the Console.
Orient the batteries as shown by the markings
inside the battery compartment. Then, reattach
the battery cover.
Note: The Console (4) can also be operated
with an optional power supply (not included)
instead of batteries.
To purchase a power
supply, call the telephone number on the
front cover of this manual.
Plug one end of
the power supply into the jack on the Console.
Plug the other end of the power supply into an
appropriate outlet that is properly installed in
accordance with all local codes and ordinances.
5
6.
Tip: Be careful not to pinch the wires during
this step.
While a second person holds the Console (4)
near the Upright (2), connect the console wire to
the Wire Harness (100).
Attach the Console (4) with four M4 x 16mm
Flat Head Screws (94).
6
4
4
2
94
96
94
100
Console Wire
Batteries
Batteries
Cover
Avoid pinching
the wires during
this step
Screws
