8
8. Apply a generous amount of grease to the axle on
the left Disc Crossbar (16). Slide the Left Pedal Arm
(11) onto the axle and attach it with an M8.5 Washer
(35) and an M8 Nylon Locknut (38).
Insert the left Handlebar Arm (5) into the bracket on
the end of the Left Pedal Arm (11), and attach it with
a Pedal Arm Bolt Set (40).
Repeat this step to attach the right Pedal Arm (not
shown).
See step 6. Tighten the M8 x 45mm Button Bolts (50)
in the Handlebar Arms (5).
Tighten the two M10 x 74mm Button Bolts (27).
8
5
11
35
38
27
40
40
Grease
16
7. Apply a generous amount of the included grease to
the left axle on the Upright (2) and inside of the two
small Handlebar Bushings (49) in the Left Handlebar
(6).
Slide a Frame Spacer (48), a Handlebar Spacer (47),
the Left Handlebar (6), and a Handlebar Cap (46) onto
the left axle on the Upright (2) as shown. Slide an M10
Washer (55) onto an M8 x 19mm Shoulder Screw (56),
and tighten the Shoulder Screw into the axle.
Attach the Right Handlebar (8) in the same way.
7
48
2
46
8
6
55
56
47
49
Grease
10. Make sure that all parts of the elliptical trainer are properly tightened. Place a mat under the elliptical
trainer to protect the floor or carpet from damage.
9. Find the Left Pedal (13), which has a ridge on the
right side. Attach the Left Pedal to the Left Pedal Arm
(11) with three M4 x 19mm Flange Screws (36) as
shown.
Attach the Right Pedal to the Right Pedal Arm (not
shown) in the same way.
11
9
13
36
