11
7. With the help of a second person, hold the con-
sole assembly near the Right Handrail (95).
Insert the Upright Wire (71) through the three
looped Wire Ties (75) under the console
assembly.
Next, connect the ground wire from the console
assembly to the Console Ground Wire (80) on
the Pulse Crossbar (97).
See the inset drawing. Connect the Upright
Wire (71) to the console wire. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER.
Console
Assembly
71
80
97
75
75
7
Ground
Wire
Console Wire
71
Console
Wire
8
79
79
79
79
8. Attach the console assembly with ten #8 x 3/4"
Screws (79); start all ten Screws, and then
tighten them. Make sure that no wires are
pinched.
Insert the wires into the console assembly. Then,
tighten the three Wire Ties (75) around the wire
and cut off the ends of the Wire Ties.
Console Assembly
95
75
