12
11
11. Attach the Latch Housing (67) to the Left Upright
(66) with two #10 x 3/4" Screws (8); start both
Screws, and then tighten them. Make sure
that the large hole in the Latch Housing is on
the indicated side.
Locate the Latch Pin Assembly (68). Remove the
knob from the pin. Make sure that the collar and
the spring are on the pin. (Note: If there are two
collars, place one on each side of the spring.)
Insert the pin into the Latch Housing (67). Then,
tighten the knob onto the pin.
12. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill.
Note: Extra parts may be included. Keep the included hex keys in a secure place; one of the hex keys is used
to adjust the walking belt (see pages 21 and 22).
67
8
66
68
Knob
Spring
Large Hole
Pin
Collar
