17
4. Change the incline of the treadmill as desired.
To change the incline of
the treadmill, press the
Incline increase and de-
crease buttons or one of
the numbered incline
buttons. Each time you
press the incline increase or decrease button, the
incline will change by 0.5 percent. If you press one
of the numbered incline buttons, the treadmill will
adjust to the selected incline setting. Note: After
you press the buttons, it may take a moment for
the treadmill to reach the selected incline setting.
5. Monitor your progress with the matrix and the
displays.
The matrix
—When the
manual mode is se-
lected, the display will
show a track that repre-
sents 1/4 mile (400 me-
ters). As you exercise,
the indicators around
the track will light in succession until the entire
track is lit. The track will then darken and the indi-
cators will again begin to light in succession.
Time display
—When
the manual mode is se-
lected, this display will
show the elapsed time.
When a workout is se-
lected, the display will
show the time remaining in the workout rather than
the elapsed time.
Distance/Incline dis-
play
—This display
shows the distance that
you have walked or run.
This display will also
show the incline setting
for several seconds, each time the incline changes.
Calories/Pulse
display
—This display
shows the approximate
number of calories you
have burned. The dis-
play will also show your
heart rate when you use the handgrip pulse sensor
or the volume level when you press the Volume in-
crease or decrease button.
Speed display
—This
display shows the speed
of the walking belt.
To reset the displays, press the Stop button, re-
move the key, and then reinsert the key.
6. Measure your heart rate if desired.
Before using the
handgrip pulse
sensor, first re-
move the sheets
of clear plastic
from the metal
contacts. In addi-
tion, make sure
that your hands
are clean.
To use the handgrip pulse sensor,
stand on the
foot rails
and hold the metal contacts—
avoid
moving your hands.
When your pulse is detected,
dashes will appear in the display and then your
heart rate will be shown.
For the most accurate
heart rate reading, continue to hold the con-
tacts for about 15 seconds.
7. Turn on the fan if desired.
The fan features low and high speed settings.
Press the Fan button repeatedly to select a fan
speed or to turn off the fan. Note: If the fan is on
when the walking belt is stopped, the fan will turn
off automatically after a few minutes.
8. When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest set-
ting or you may damage the treadmill when you
fold it to the storage position.
Next, remove the
key from the console and put it in a secure place.
When you are finished using the treadmill, switch
the reset/off circuit breaker to the off position and
unplug the power cord.
IMPORTANT: If you do
not do this, the treadmillʼs electrical compo-
nents may wear prematurely.
Contacts
