Pro-Form 725ex PFTL72582, User Manual

4. SYMPTOM: THE DISPLAYS OF THE CONSOLE DO NOT FUNCTION PROPERLY

a. Remove the key from the console and 

UPLUG THE POWER

CORD. 

Remove the screws from the hood. Carefully remove the

hood. Locate the Reed Switch (26) and the Magnet (107) on the
left side of the Pulley (12). Turn the Pulley until the Magnet is
aligned with the Reed Switch. 

Make sure that the gap between

the Magnet and the Reed Switch is about 1/8Ó.

If necessary,

loosen the Reed Switch Screw (109) and move the Reed Switch
slightly. Retighten the Screw. Re-attach the hood, and run the
treadmill for a few minutes to check for a correct speed reading.

5. SYMPTOM: The walking belt slows when walked on

a. Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length. 

b. If the walking belt is overtightened, treadmill performance may

decrease and the walking belt may be permanently damaged.
Remove the key and 

UNPLUG THE POWER CORD

. Using the

allen wrench, turn both rear roller adjustment bolts counterclock-
wise, 1/4 of a turn. When the walking belt is properly tightened,
you should be able to lift each side of the walking belt 3 to 4
inches off the walking platform. Be careful to keep the walking
belt centered. Plug in the power cord, insert the key and run the
treadmill for a few minutes. Repeat until the walking belt is prop-
erly tightened.

c. If the walking belt still slows when walked on, please call our

Customer Service Department, toll-free.

6. SYMPTOM: The walking belt is off-center

a. If the walking belt has shifted to the left, first remove the key and

UNPLUG THE POWER CORD

. Using the allen wrench, turn the

left rear roller adjustment bolt clockwise, and the right bolt coun-
terclockwise, 1/4 of a turn each. Be careful not to overtighten the
walking belt. Plug in the power cord, insert the key and run the
treadmill for a few minutes. Repeat until the walking belt is cen-
tered. 

b. If the walking belt has shifted to the right, first remove the key

and 

UNPLUG THE POWER CORD

. Using the allen wrench, turn

the left rear roller adjustment bolt counterclockwise, and the right
bolt clockwise, 1/4 of a turn each. Be careful not to overtighten
the walking belt. Plug in the power cord, insert the key and run
the treadmill for a few minutes. Repeat until the walking belt is
centered.

7. SYMPTOM: The walking belt slips when walked on

a. If the walking belt slips when walked on, first remove the key and

UNPLUG THE POWER CORD

. Using the allen wrench, turn

both rear roller adjustment bolts clockwise, 1/4 of a turn. When
the walking belt is correctly tightened, you should be able to lift
each side of the walking belt 3 to 4 inches off the walking plat-
form. Be careful to keep the walking belt centered. Plug in the
power cord, insert the key and carefully walk on the treadmill for
a few minutes. Repeat until the walking belt is properly tightened.

Rear Roller Adjustment Bolts

3ÓÐ4Ó

b

b

a

a

107

26

109

Top 

View

1/8Ó

12

15