6
1. Identify the Front Stabiliser (2). While another person
lifts the front of the Frame (1) slightly, attach the Front
Stabilizer to the Frame with two M10 x 65mm Carriage
Bolts (65) and two M10 Black Nylon Locknuts (63).
Make sure that the Front Stabiliser is turned so the
Wheels (50) are not touching the floor.
2
50
50
63
65
1
1
2. While another person lifts the back of the Frame (1)
slightly, attach the Rear Stabilizer (9) to the Frame with
two M10 x 65mm Carriage Bolts (65) and two M10
Black Nylon Locknuts (63).
65
9
1
3
13
1
36
73
64
14
14
14
71
70
64
2
63
63
4. The Console (16) requires four “D” batteries (not
included); alkaline batteries are recommended.
Remove the screw from the battery drawer. Pull the
battery drawer open and insert four batteries.
Make
sure that the batteries are oriented as shown by
the markings inside the battery drawer.
Close the
battery drawer and reattach the screw. Note: When the
batteries are installed correctly, the fan will turn on for a
moment.
16
Batteries
Battery
Drawer
4
Screw
3. Whilst another person holds the Upright (13) in the
position shown, connect the Upper Wire Harness (36)
to the Lower Wire Harness (73).
Slide the Upright (13) onto the Frame (1).
Be careful to
avoid pinching the Wire Harnesses (36, 73).
Attach
the Upright to the Frame with three M8 x 25mm Button
Screws (14) and three M8 Split Washers (64).
Attach the Water Bottle Holder (70) to the Upright (13)
with two M4 X 22mm Screws (71).
All manuals and user guides at all-guides.com
all-guides.com
