8
5. Hold a Bolt Spacer (84) inside the lower end of
the Right Upright (79). Insert a 3/8" x 4" Bolt (5)
with a 3/8" Star Washer (12) into the Right
Upright and the Bolt Spacer.
Repeat this step
with a second Bolt Spacer (84), 3/8" x 4" Bolt
(5), and 3/8" Star Washer (12).
Hold the Right Upright (79) against the Right
Upright Spacer (83).
Be careful not to pinch
the Wire Harness (86).
Tighten the 3/8" x 4"
Bolts (5) until the heads of the Bolts touch the
Right Upright;
do not fully tighten the Bolts
yet.
83
79
86
12
84
5
5
4. Identify the Right Upright (79) and the Right
Upright Spacer (83). Insert the Wire Harness
(86) through the Right Upright Spacer as shown.
Set the Right Upright Spacer on the Base (60).
With the help of a second person, hold the Right
Upright (79) near the Base (60).
See the inset
drawing.
Tie the wire tie in the Right Upright se-
curely around the end of the Wire Harness (86).
Then, pull the other end of the wire tie until the
Wire Harness is routed completely through the
Right Upright.
60
Wire Tie
86
79
83
86
4
Wire
Tie
79
86
