12
A
A
B
B
D
C
E
B
D
A
A
SPA SHELL DIAGRAM
SPA OPERATION
Refer to the diagram above. The function of each
component is explained below:
The six uni-directional thera-jets (A) are located on
both sides of the spa. Five jets focus the water mas-
sage on your upper or lower back. The remaining jet
provides a foot hydro-massage when you are in the
reclining seat.
The three multi-directional thera-jets (B) can be
adjusted for a custom hydro-massage. Each thera-jet
can also be shut off by being pressed in and turned
back on by pulling the jet back out.
One of the jets is located on the reclining seat and
focuses the water massage on your lower back.
Another jet is located on one of the bench seats,
below a uni-directional thera-jet, and focuses the
water massage on your lower or middle back. The
remaining jet, located on the other bench seat, focus-
es the water massage on your upper or lower back.
The filter (C) can be removed for replacement and
cleaning (see page 16).
The suction vents (D), located near the floor of the
spa, bring the water into the pump, in order to operate
the system. The suction covers should always be in
place over the suction vents. Never operate the spa
without the suction covers in place.
This spa is ozone ready. An optional ozone generator
can be installed to utilize the ozone jet (E). Ozone
provides a way to help sanitize your spa with minimal
chemical treatment.
The temperature probe (F) reads the current water
temperature, which is displayed on the console.
The spa also has a light (G) for evening use.
The RESTORATION 510 features automatic freeze
protection. If the water temperature falls below 40°F,
the pump will begin circulating and heating the water
to prevent the water from freezing.
F
G
Summary of Contents for 831.100420
Page 24: ...NOTES 24 ...