8
6. Orient the Console Plate (11) as shown. Then,
insert the Main Wire (53) and the Frame Pulse
Wire (42) upward through the Console Plate.
Tip: Avoid pinching the wires.
Insert the
Console Plate (11) into the Upright (2).
Orient the Handlebar (13) as shown.
Tip: Avoid
pinching the wires.
Attach the Handlebar and
the Console Plate (11) to the Upright (2) with two
M8 x 20mm Screws (55).
Avoid pinching
the wires
53
42
13
55
11
2
4
Battery
Cover
7. The Console (4) can use four D batteries (not
included); alkaline batteries are recommended.
Do not use old and new batteries together or
alkaline, standard, and rechargeable batter-
ies together.
IMPORTANT: If the Console has
been exposed to cold temperatures, allow it
to warm to room temperature before insert-
ing batteries. Otherwise, you may damage
the console displays or other electronic
components.
Remove the battery covers from the back of the
Console (4), and insert batteries into the battery
compartments.
Make sure to orient the bat-
teries as shown by the diagrams inside the
battery compartments.
Then, reattach the bat-
tery covers.
To purchase an optional power adapter, call
the telephone number on the cover of this
manual. To avoid damaging the console,
use only a manufacturer-supplied power
adapter.
Plug one end of the power adapter into
the receptacle inside the battery compartment
on the console; plug the other end into an outlet
installed in accordance with all local codes and
ordinances.
Battery
Cover
Receptacle
6
7
