9
5. Apply a generous amount of the included grease
to the Pivot Axle (33) and to two 5/8" Wave
Washers (102).
Tip: Avoid pinching or damaging the Upper
Wire Harness (97).
Insert the Pivot Axle (33)
through the Upright (6). Then, slide a 5/8" Wave
Washer (102) onto each end of the Pivot Axle.
Slide an Upper Body Arm (12) onto the left side
of the Pivot Axle (33). Attach the Upper Body
Arm with a 5/16" x 1" Screw (81), a Large Axle
Cover (94), and a 5/16" Washer (104).
Attach the other Upper Body Arm (12) in the
same way.
5
81
94
12
12
102
102
94
33
6
Grease
97
81
104
104
6
6. Identify the Right Pedal Plate (107). Attach the
Right Pedal Plate to the Right Pedal Arm (8) with
three M10 x 20mm Screws (108) and three M10
Split Washers (110).
Identify the Right Pedal Assembly (62), which
is located in a package marked with a “Right”
sticker.
Attach the Right Pedal Assembly (62) to the right
Pedal Plate (107) with five #10 x 1/2" Screws
(79), five M6 Split Washers (111), and five #10
Fender Washers (80).
Tip: To avoid damaging
the Pedal, do not overtighten the Screws.
Repeat this step for the Left Pedal Plate (not
shown) and the Left Pedal Assembly (56).
80
62
108
107
56
79
79
8
110
111
