8
5
118
119
Grease
Tube
2
31
3
Lubricate
128
Cutout
5. Slide a Weld Spacer (119) onto the axle on the left
side of the Upright (2); make sure that the open side
of the Weld Spacer is facing the Upright. Next, apply a
small amount of grease to the axle.
Identify the Left Upper Body Arm (118), which is
marked with a sticker. Remove the Upper Body Leg
(31) from the Left Upper Body Arm. Apply a small
amount of the included high-temperature lubricant to a
paper towel, and rub a thin film of the lubricant onto
the Upper Body Leg. Then, reinsert the Upper Body
Leg into the Left Upper Body Arm.
Slide a Handlebar Cover (26) onto the indicated tube
on the Left Upper Body Arm (118). Hold the Left
Upper Body Arm with one hand, hold the Upper Body
Leg (31) with your other hand, and slide the Left
Upper Body Arm onto the axle on the left side of the
Upright (2). Then, extend the Upper Body Leg until it
rests on the Ramp (3).
Repeat this step with the Right Upper Body Arm
(128).
26
85
105
86
127
Cutout
86
24
23
2
26
114
20
6
6. Have another person hold the Left Handlebar (24)
near the Upright (2). Connect the left Pulse Sensor
Wire (20) to the Pulse Extension Wire (114). Next,
slide a Handlebar Cap (127) onto the lower end of the
Left Handlebar.
Slide the upper end of the Left Handlebar (24) into the
tube on the front of the Upright (2), while sliding the
lower end of the Left Handlebar onto the axle on the
left side of the Upright. Attach the upper end of the
Left Handlebar with two M8 x 42mm Button Bolts (85)
and two M8 Jam Nuts (86);
be careful not to dam-
age the Wires (20, 114) as you insert the Button
Bolts. Make sure that the Jam Nuts are resting in
the hexagonal holes in the Left Handlebar.
Attach
the lower end of the Left Handlebar with an M8 x
38mm Button Bolt (105) and an M8 Jam Nut (86).
Then, press the tabs on the Handlebar Cap (127) into
the left Handlebar Cover (26).
Attach the Right Handlebar (23) in the same way.
