background image

14

3

CONDITIONING GUIDELINES

The following guidelines will help you to plan your ex-
ercise program. RememberÑthese are general guide-
lines. For more detailed information about exercise,
obtain a reputable book or consult your physician. 

EXERCISE INTENSITY

Whether you want to burn fat, strengthen your cardio-
vascular system, or increase your athletic perfor-
mance, you can tailor your exercise to your specific
goals. The key to achieving the desired results is to ex-
ercise with the proper intensity. 

Burning Fat

To burn fat effectively, you must exercise at a relatively
low intensity level for a sustained period of time.
During the first few minutes of exercise, your body
uses easily accessible 

carbohydrate calories

for en-

ergy. Only after the first few minutes of exercise does
your body begin to use stored 

fat calories

for energy. 

If your goal is to burn fat, set the speed control on the
console to FAT BURN to help you maintain the proper
intensity level. (See pages 8 and 9.)

Aerobic Exercise

If your goal is to strengthen your cardiovascular sys-
tem, your exercise must be Òaerobic.Ó Aerobic exercise
is activity that requires large amounts of oxygen for
prolonged periods of time. This increases the demand
on the heart to pump blood to the muscles, and on the
lungs to oxygenate the blood. The proper intensity
level for aerobic exercise can be found by using your
pulse as a guide. As you exercise, your pulse should
be kept at a level between 70% and 85% of your maxi-
mum possible heart rate. This is known as your train-
ing zone. You can find your training zone in the table
at the top of this page. Training zones are listed ac-
cording to age and physical condition. 

During the first few months of your exercise program,

keep your pulse near the low end of your training zone
as you exercise. After a few months of regular exer-
cise, your pulse can be gradually increased until it is
near the middle of your training zone as you exercise.
You can measure your pulse using the pulse sensor.
Exercise for about four minutes, and then measure
your pulse immediately. If your pulse is too high or too
low, adjust the intensity of your exercise. It may also
be helpful to set the speed control on the console to
AEROBIC to help you maintain the proper intensity
level. (See pages 8 and 9.) 

Performance Training

If your goal is high performance athletic conditioning,
set the speed control on the console to PERFOR-
MANCE to help you maintain the proper intensity level.
(See pages 8 and 9.)

WORKOUT GUIDELINES

Each workout should include three parts: (1) a warm-
up, (2) training zone exercise, and (3) a cool-down. 

Warm-up

Warming up prepares the body for exercise by increas-
ing circulation, delivering more oxygen to the muscles
and raising the body temperature. Begin each workout
with 5 to 10 minutes of stretching and light exercise to
warm up (see SUGGESTED STRETCHES on page 15).

WARNING:

Before beginning

this or any exercise program, consult your
physician. This is especially important for in-
dividuals over the age of 35 or individuals
with pre-existing health problems.

The pulse sensor is not a medical device.
Various factors, including your movement,
may affect the accuracy of heart rate readings.
The sensor is intended only as an exercise aid
in determining heart rate trends in general.

20

138-167

133-162

25

136-166

132-160

30

135-164

130-158

35

134-162

129-156

40

132-161

127-155

45

131-159

125-153

50

129-156

124-150

55

127-155

122-149

60

126-153

121-147

65

125-151

119-145

70

123-150

118-144

75

122-147

117-142

80

120-146

115-140

85

118-144

114-139

Age

Unconditioned

Conditioned

Training Zone (Beats/Min.)

The decals shown below have been placed on your treadmill. If one of the decals is missing, or if it is not
legible, please call our Customer Service Department to order a free replacement decal (see ORDERING
REPLACEMENT PARTS on the back cover of this manual). Apply the decal in the location shown.

readings. The pulse sensor is intended only
as an exercise aid in determining heart rate
trends in general.

18. Never leave the treadmill unattended whilst it

is running. Always remove the key when the
treadmill is not in use. 

19. You must be able to safely lift 45 pounds

(20 kg) to raise, lower, or move the treadmill.

20. When folding or moving the treadmill, make

sure that the storage latch is fully closed.

21. Inspect and tighten all parts of the treadmill

every three months.

22. Never insert any object into any opening.

23. Always unplug the power cord before per-

forming the maintenance and adjustment
procedures described in this manual. Never
remove the motor hood unless instructed to
do so by an authorised service representa-
tive. Servicing other than the procedures in
this manual should be performed by an au-
thorised service representative only.

WARNING:

Before beginning this or any exercise program, consult your physician. This

is especially important for persons over the age of 35 or persons with pre-existing health problems.
Read all instructions before using. ICON assumes no responsibility for personal injury or property
damage sustained by or through the use of this product.

SAVE THESE INSTRUCTIONS

Summary of Contents for CROSS-WALK CSI PETL21462











Reviews: